09-13-2019, 01:49 PM
Hello, I'm new to this forum and 3d SLA printing,I hope that you have a solution to a mistake that i did...
I've just received the elegoo Mars printer and the first i thing was to do a wrong calibration of the touch screen.
Then, i can't use it normaly. As i've seen on a post i removed the two ribbons on the back of the screen, ect...
The screen always works but with the same problem.
I decided to try a new firmware but the problem persists.
Do you have a solution? Thank you.
Sorry for my english... It's possible that you understand me.
