Elegoo 3D Printers Forum - Prints Sticking to the FEP Film

Current time: 03-11-2025, 01:06 PM Hello There, Guest! Register

Users browsing this forum: 4 Guest(s)

Pages (2): « Previous 1 2

Mark this forum read Prints Sticking to the FEP Film
Thread / Author			Replies	Views	Rating	Last Post [asc]
		I love printing round disks on FEP... but time to move on (Pages: 1 2 ) Bigmds	17	37,659	1 Vote(s) - 5 out of 5 in Average	05-01-2020, 07:57 AM Last Post: kingranger
		Prints sticking to resin vat bottom Pixacor	9	30,370	0 Vote(s) - 0 out of 5 in Average	03-15-2020, 12:54 AM Last Post: TristanA
		FEP film tearing ShareBits	0	3,528	0 Vote(s) - 0 out of 5 in Average	01-13-2020, 07:57 AM Last Post: ShareBits
		Nothing sticks to the left side of the print bed morgan164	3	9,472	0 Vote(s) - 0 out of 5 in Average	01-07-2020, 11:54 PM Last Post: morgan164
		everything sticks to the fep except the towers robertogrosso	2	7,828	0 Vote(s) - 0 out of 5 in Average	12-14-2019, 07:59 AM Last Post: robertogrosso
		Print on fep (Pages: 1 2 ) caesar	18	38,411	0 Vote(s) - 0 out of 5 in Average	12-10-2019, 01:28 AM Last Post: ZX-Sinclair
		All the prints get stuck to FEP swordman	3	29,902	0 Vote(s) - 0 out of 5 in Average	11-25-2019, 03:46 AM Last Post: DarkDust
		Elegoo prints on FEP only xcyx	1	11,243	0 Vote(s) - 0 out of 5 in Average	10-31-2019, 11:36 AM Last Post: VDX

Pages (2): « Previous 1 2

New Posts

Hot Thread (New)

Hot Thread (No New)

No New Posts

Contains Posts by You

Closed Thread

Forum Jump: